: For a visual walkthrough, check out this guide on How to Mull Two Vinyl Windows Together . Window mullion installation #Lowes
Mulling is the process of joining two or more windows together to fit into a single large opening. If you are using a , the process involves preparing the frames, applying sealant, and securing the units with structural connectors. ReliaBilt Window Mull Kit Installation Steps reliabilt-window-mull-kit-instructions
: Apply additional silicone sealant to the top and bottom of the mull joint, filling any voids. If your kit includes a drip cap or mull bridge , install and seal these over the top and bottom exterior joints. Helpful Resources : For a visual walkthrough, check out this
: Open the window sashes to access the factory pre-drilled holes or specific reinforcement areas. Drive the provided screws through one frame into the other (staggering them if necessary) to pull the units tightly together. ReliaBilt Window Mull Kit Installation Steps : Apply
: If your windows have nailing fins or J-channels on the sides being mulled, remove them using pliers or a utility knife to allow the frames to sit tightly together.
: Align the windows and press the mullion strip (the H-shaped or snap-on piece from your kit) into the channel. You may need a rubber mallet to gently tap the strip into place until it snaps securely.
: Lay the windows side-by-side on a flat surface. Use a utility knife to trim any excess vinyl "welds" or protruding edges from the corners where the windows will meet to ensure a flush fit.
