Instruktsiia Po Ustanovki Dveri Kupe Page

Angle the top into the rear groove of the upper track, then lower the bottom rollers into the rear groove of the bottom track. Repeat the process for the . 4. Final Adjustments

: If your kit includes stoppers or soft-close mechanisms, slide them into the top track and tighten them at the points where the doors should stop. Recommended Tools Level and tape measure Drill with pilot bits Hacksaw (to trim tracks) Screwdriver (for adjustment screws) Installing a Sliding Closet Door Track instruktsiia po ustanovki dveri kupe

: If the door doesn't sit flush against the wall, locate the adjustment screws on the bottom rollers. Angle the top into the rear groove of

For , align the lower track with the top one using a level or plumb line. Final Adjustments : If your kit includes stoppers

: Turning these screws clockwise or counter-clockwise will raise or lower that side of the door to make it plumb.

: Measure the opening in three places (top, middle, bottom for width; left, center, right for height).