How To Make An Orgone Field Pulser May 2026

Place the crystal (with the coil wrapped around it) and the electronic circuit into a mold. Fill the mold with a 50/50 mix of metal shavings and resin.

Solder the output leads of your frequency generator to the two ends of the Mobius coil. Attach a power switch and a 9V battery snap to the circuit.

Clear casting resin, metal shavings (copper, brass, or aluminum), and a single-terminated quartz crystal . How To Make An Orgone Field Pulser

The heart of the pulser is the , which is wound in a way that its magnetic fields cancel each other out, theoretically creating a "scalar" or "longitudinal" wave. Fold a long piece of insulated wire in half.

Twist the wire together using a drill or by hand to create a "bifilar" twist. Place the crystal (with the coil wrapped around

An Orgone Field Pulser (OFP) is a specialized device designed to generate a "pulsed" energy field by combining traditional (a mixture of resin, metal, and crystals) with an electronic frequency generator . Unlike a passive orgone accumulator, which simply gathers ambient energy, a pulser uses a Mobius coil driven by an electrical signal to actively broadcast a specific frequency, often the Schumann Resonance (7.83Hz). How to Make an Orgone Field Pulser

Building a pulser requires both structural assembly and electronic wiring. Attach a power switch and a 9V battery snap to the circuit

A Mobius coil (usually made from 20-30 gauge insulated copper wire), a 9V battery connector, and a zapper or frequency generator circuit (often based on an LM555 timer chip ).